ISTQB Foundation Level Q&A

Practice ISTQB Foundation Level Q&A – Which is not the testing objectives

Practice ISTQB Foundation Level Q&A – System testing should investigate

Practice ISTQB Foundation Level Q&A – Poor software characteristics are

Practice ISTQB Foundation Level Q&A – Important consequences of the impossibility of complete testing are (Choose one or more answers):

Practice ISTQB Foundation Level Q&A – Measurement dysfunction is a problem because:

Practice ISTQB Foundation Level Q&A – Reviews, static analysis and dynamic testing have the same objective

Practice ISTQB Foundation Level Q&A – A defect arrival rate curve:

Practice ISTQB Foundation Level Q&A – Which of the following is a purpose of the review planning phase?

Practice ISTQB Foundation Level Q&A – Which of the following combinations correctly describes a valid approach to component testing:
(i) Functional testing of the component in isolation.

(ii) Structure-based testing of the code without recording incidents.

(iii) Automated tests that are run until the component passes.

(iv) Functional testing of the interfaces between modules.

Practice ISTQB Foundation Level Q&A – Which of the following is MOST characteristic of specification based (black-box) techniques?

Practice ISTQB Foundation Level Q&A – What is the MINIMUM combination of paths required to provide full statement coverage? Exhibit:

Practice ISTQB Foundation Level Q&A – Which of the following is a benefit of test independence?
(v)It does not require familiarity with the code.

(w) It is cheaper than using developers to test their own code.

(x) It avoids author bias in defining effective tests.

(y) Testers are better at finding defects than developers.

(z) The above diagram represents the following paths through the code.

Practice ISTQB Foundation Level Q&A – Which of the following is MOST important in the selection of a test approach?

Practice ISTQB Foundation Level Q&A – Which of the following types of defects is use case testing MOST LIKELY to uncover?
(i) Defects in the process flows during real-world use of the system.

(ii) Defects in the interface parameters in integration testing.

(iii) Integration defects caused by the interaction and interference of different components.

(iv) Defects in the system as it transitions between one state and another.

Practice ISTQB Foundation Level Q&A – For which of the following would a static analysis tool be MOST useful?